7.5 TED WILLIAMS OUTBOARD MOTOR MANUAL
(It went from Scott to McCulloch to Chrysler.) Check out the Chrysler service manual for an idea of how it works. Mine had the same basic engine as a Tecumseh. This motor is a 2 cycle model, A lot better than the newer 4 cycle models It has a 2 3/4 qt. All were two stroke engines and used premixed oil and gas. 5.5 HP Sears, Ted Williams model Outboard Motor - 300 (Roseville) 1975 5.5 HP Sears, Ted Williams model Outboard Motor In new condition This motor was purchased in 1975, used three times in 1975 and has been stored in the garage ever since. It has a water pump and must be run in water or it will over heat eventually. I believe the Ted Williams outboard uses the Scott system. Top is air cooled but the lower leg, exhaust and the bottom wall of the block is water cooled. Mercury Used a hollow shaft but rotated the shift rod to change gears. Scott Atwater used a hollow prop shaft with a step tapered cam on the end of the shift rod engaging the spring loaded dog clutch with a rod through the center of the prop shaft. 1965 Sear 7.5 HP Ted Williams Outboard motor with Forward and Reverse - 250 (Quanicassee) For Sale 1965 Sear 7.5 HP Ted Williams Outboard short shaft motor with Forward, Neutral and Reverse, a 3 blade prop, 2.5 gallon remote tank with gas line and connector fitting including origonal owners manual. Selling as follows: - engine block/power head model number T640-07A has very good compression of. Parting out a mid-1970s, 7.5hp, 2 stroke Ted Williams outboard sold by Sears, manufactured by Eska, and powered by an air cooled, single cylinderTecumseh engine. OMC used a yoke coupled with a right angle lever to transfer the up and down of the shift rod to the forward & backward motion of the dog clutch. parts off a mid 70s 7.5 hp Ted Williams outboard motor City of Toronto. The patent was on how the clutch is moved. (The motor should be idling at this time.) The dogs will then drop into spaces between the dogs in the gear. When the shift lever is moved to forward, it pushes the dogs against the forward gear. McCulloch company built outboards for Sears from 1959 to 1968. The pinion drives them in opposite directions.The dog clutch is in the middle and when in neutral does not touch either one. 1965 Sear 7.5 HP Ted Williams Outboard short shaft motor - 250 (Quanicassee) For Sale 1965 Sear 7.5 HP Ted Williams Outboard short shaft motor with Forward, Neutral and Reverse, a 3 blade prop, 2.5 gallon remote tank with gas line and connector fitting including origonal owners manual. If the model number of a Sears or Ted Williams outboard begins with 217. If the motor is identified as an 'Eldin,' 'Sears' or 'Ted Williams,' its model number prefix is 574, and it was built by McCulloch between 19. The forward and reverse gears are both engaged with the pinion gear on the drive shaft. Look at the motors product name: if the motor is an 'Elgin,' it was built between 19 by West Bend. These parts are all at our Pennsylvania location which is open from April 1st thru September 26th. The way a dog clutch works is to slide into spaces in the gear. SEARS GAMEFISHER, 15 SPEED ELECTRIC TROLLING MOTOR.